Hello! Ezequiel here. customCommands should be inside the config of the Remote Control. You can raise a question in the issue page for further instructions. Cheers 
MagicMirror² v2.16.0 is available! For more information about this release, check out this topic.
E
Latest posts made by ezeholz
-
RE: Custom Commands in @MMM-Remote-Controlposted in Troubleshooting
-
RE: VGA Montitorposted in Hardware
Hey! So, there are probably a lot of ways to turn on and off your monitors, but I’m gonna link the one that worked for me. I was using MMM-Remote-Control, but you can take those commands and run them expecting to turn on and off.
https://github.com/Jopyth/MMM-Remote-Control/issues/168#issuecomment-572890815