@madscientist said in Powering my monitor: @flavito five nights at freddy’s You posted the model type of the LCD panel. So I assume you don’t have a complete monitor but just the naked panel. Hence your question about connecting it to the pi. What you need is a LCD controller board. I wrote a lot about those in this forum already and I don’t want to repeat myself all the time. So have a look here and here. Maybe use the forum search. You should find all the information you need. What I can tell you is that your panel is 21.5 inch, FullHD (1920x1080) and it has a 30-pin 2-Channel, 8-bit interface. You’ll find solutions as cheap as 3-4€ with a bit of hands-on work, 10€ for plug’n’play but a relay is needed if you want to use a PIR-sensor, or 30€ for a board with the needed firmware pre-installed. They all have pros (e.g. price) and cons (custom wiring). Read a bit and if you have further questions you just ask again. Usually I look at the forum daily or at least every two days. Disclaimer: I am with no means an expert here. I just went through the same research when I build my mirror. i got it, thank you for the explanation.