I was wondering if it could be controlled by the raspberry pi itself, when you set up the MagicMirror2, you run through the audio settings for the mic and sound out put…

Is there any way to control volume from here??

I’m in the middle of building my first MagicMirror2, and yes it’s a fun project.

I’m just wondering if there is a way to control the volume using voice control??

Eg saying volume up or down

I’m running from usb sound card to a little 50w x 2 to two speakers.

Any ideas would be grate full

@mykle1 fantastic walk through, thanks for that link to your post, a lot of information I needed to start me on my way

Thanks for the reply, so iv go the mm running, using the test config file, iv all so changed the wireless settings so it doesn’t turn off, iv deleted the compliment part of the code, I was going to use the test config and adjust for my needs and try to learn the basics of coding well try

I’ll jump straight on the links you provide thanks

OK so (as my son would call me) I’m a total Newbie when it come to all this, iv never done anything thing like this before iv never even touched a pi before unless it had a filling.

So far iv downloaded (manual installation) MagicMirror2 and MMM-AssistantMk2 and that’s as far as iv got, I’m guessing I’m a little out of my depth.

Is there any guides about to help people like me remembering that I know NOTHING, I’m ok with all the electronic side of things it’s just the software iv not got a clue sorry to say.

I have looked about but most of everything I’m finding is about installing not modding or adding modules so Any help would be great

Thanks

@cr4z33 OK thanks mate

Sorry this is my first post, are there any guides for helping me install the MMM-assistantMK2 I’m a total beginner With the raspberry pi any help would be much appreciated