Good evening, all.
As promised a status update regarding my activities with my signage board.
After several brain distorsions with the software part (you may have seen my dumb questions) I also spent some time in the hardware part.
I will place the monitor in a wooden frame (not ready, yet) and use a passepartout for design purposes.
To do so I’ve designed
[image: 1738510459685-passepartoutframesketch.png]
a frame for the mirror, print this in pieces (PETG HF)
[image: 1738510697089-passpartoutframe_parts.jpg]
and assembled this to one connected piece (glued)
[image: 1738510882718-passepartoutframe_assembled.jpg]
Wooden strips will be placed on the outer side (therefore the drill holes) to correspont with the wooden frame.
The slot on the bottom left side is for eventually using the monitor buttons (through the “final” (paper) passepartout which will be placed on top of the plastic frame.
So far a little bit progress.
Will keep you posted.
Regards,
Ralf
