I’m using an evaluation Module - DLPDLCR2000EVM , about £100 UKP. Things to note: I think it was a limited run, Farnell have been sold out for some time, and digikey’s stock is dropping. Resolution is LOW 640x360 Its designed for a BeagleBone Black, I used a Pi Zero W adapter board from MickMake on tindie, needs soldering though. It’s powered off a 5v wall-wart, no battery (though I think MickMake may be working on that) no enclosure no firmware customization, it boots to a bright splash screen and then you have to fiddle around sending I2C commands. Soldered in you have NO GPIO left over for anything at all Soldered in the usb ports are inaccesible the zero w is somewhat underpowered, currently I’ve got MM running in docker on another Pi while I develop… I think you should be able to run both on the same device There’s a very faint blue patch visible when all is black, seems to be a design fault, I returned one, but the second is the same. All in all not perfect, but I’m used to that.

Ive tried to install this onto my project however I am not able to load the module up. The error is located to API key. modules: { module: “MMM-metoffice-datapoint”, // Weather app. position: “right”, config: { apikey: “<<>>”, sitename: “Ashford (Kent)”, } }, can you help?