@sdetweil Thank you very much Sam, that makes life easier. I didn’t know the key combination.

@sdetweil The question is, how can I stop MM in order to go back to the grafic desktop?

@sdetweil Hello, thank you very much, I somehow managed to do that by ‘manually’ copying the modules etc. back. But I still have the following problem. I use an original Raspi keyboard and used to get into the ‘dock’ with the ‘Berry’ key, so that I could call up the terminal and end the MagicMirror with ‘pm2 stop mm’. This no longer works and I can only get out via RealVNC. Do you have a solution for this?

Hi, got a new Pi 5 and wanted to run it with the SD Card of my Pi4. Did not work. So I had to install new OS for the Pi5. How can I get my Mirror running on this new OS ? I am afraid copy paste would not work ?

Re: UPDATE
Hi, month ago there was a post saying do not update MagigMirror as long as the system runs. My mirror sais I am 89 commits behind the master branch. My Question: is there any need to update? Same Question re the module updates?

@chrisfr1976 Dear Chris, I apologize for my unqualified question. Regards

Hi, does meanwhil one of your fronius modules work whithout Problems? Tried the second one but no display at all. What changes in the config etc. are still necessary?
Regards Walter

My solution. Cronjob to shut down the raspi and a Shelly Relay to switch the power on and off. As already mentioned here, I only switch the power off 5 minutes later. The Shelly works like a timer and you can switch on and off several times a day. It switches off the power to both the Raspi and the display. With the Shelly app or an additional switch, you can also switch on the MM outside the programmed times. If you are not familiar with 230V wiring, use a Shelly plug.

Übersetzt mit DeepL

Try to ask the guys at touchandscreen.de

@sdetweil Thank you so much. It works!