MMM-CalendarExt3 not showing events on calendar, but does on list after 2.30 update

sdetweil

@tke499 I do not yet… I checked the code that sends the list to other modules and I don’t SEE anything … ps, I personally did all the calendar updates

both versions clip the list to the config.maxEvents: value. (10 default in both)

sdetweil

@tke499 looking at the code again, there WAS a bug in prior releases, where
you COULD specify to limit the number of entries produced BY calendar

    { 
       url: "some cal url",
       maximumEntries:xxx   // default whatever the base config has for this property
    }

so, I added code to fix that bug

SO, if one does NOT specify maximumEntries in the cal url section,
it will clip to the default value,
which it did NOT DO before…

the prior bug was maxEvents said 100 (including old)
1st cal contributed 20
2nd cal contributed 100
3rd cal contributed 5

1st 100 (maxEvents) is returned… so none of cal 3 got processed…

the code and limits were present in prior release, just not the clipping

tke499

@sdetweil so I am assuming that I should just keep the coding you provided earlier correct?

sdetweil

@tke499
if it works for you

yes, next release is April 1

tke499

@sdetweil appreciate being patient with me. Thanks again. I made this MM for my wife for Christmas and it has fought me every single step.

sdetweil

@tke499 no problem… been there , done that…

thats why I do the install/upgrade, and backup/restore scripts,
and look for other ways to make the core functions easier to use

Como

@sdetweil Wondering if this hack would work for MMM-CalendarExt3Agenda? Had half my calendars stop showing events today (the ones that have the most events in them, oddly 2 of the calendars that only have 1 or 2 events are still showing). I confirmed that the events still show in the default calendar module. I also tried the troubleshooting steps listed previously in the thread (pulling the latest from git and npm install) but no luck.

Thanks as always!

sdetweil

@Como yes, all the ext3 modules get the data from the same place

Como

@sdetweil so I actually read through your posts again and saw the comment regarding the max entries. I ended up increasing the default 100 to 1000 and it the module is working as expected.

sdetweil

@Como cool in general w ext3 family you set maxevents up as it can display events in the past. which the default calendar doesn’t do