MMM-PIR-Sensor-Lite modification

[sdetweil]

@Freddy_boy you can try my MMM-SleepWake
https://github.com/sdetweil/MMM-SleepWake

it listens for pir sensor or lite to signal user presence

and mode HIDE will hide all the modules and show them again when a user appears

I built this to use this with a webcam as I don’t have any pirs, and none of my monitors will behave (big ‘no power’ warning when hdmi goes off)

I just added the code for sensor-lite, just a check …

[Freddy_boy]

I assume that I would need to re-configure the MMM-PIR-Sensor-Lite module to prevent the command from turning OFF the HDMI. How do I do that?

[sdetweil]

@Freddy_boy dang, this module also doesn’t alert other modules…

too much to change quickly… sorry

[bugsounet]

Really…

Should I recode a module by merging screen and pir plugins ??

Yes, I can do it but… I not really interested to maintened it
@sdetweil: if I add you to contributor, you are able to “maintened” it ?

I will create MMM-Pir

[wishmaster270]

@Freddy_boy
Hi, my MMM-Screen-Powersave-Notification module can do this job. It has a hideInsteadShutoffoption.
You need my MMM-GPIO-Notifications in addition.
I wrote a Guide of how to configure the modules.

[bugsounet]

@bugsounet said in MMM-PIR-Sensor-Lite modification:

I will create MMM-Pir

It’s done.
It’s based with my EXT-Screen and EXT-Pir plugins
I have rewrite and clean it for MMM using

@wishmaster270:
do you want to try to maintened it ?
I can add you as contributor
(I see that you fork EXT-Screen)
I have really no time for any MMM :/

[wishmaster270]

@bugsounet Hi,
sorry but at the moment a do not have plans to maintain more modules than i already do.
In addition i do not see a reason why there should be a need for a additional screensave module.
Most of the features are present in the exiting ones. I do not like the idea of putting the GPIO logic and screensave logic into the same module and had problems with it in my setup in the past. Thats why i created the two separted modules.
I forked MMM-Screen as i wanted to check if there is a easy way to implement the CEC logic to my screensave module. I do not think it would be a big deal. The problem is that i do not have a CEC aware monitor at the moment and do not have the time to build a dev environment with my tv.

[Freddy_boy]

Terrific! I just installed MMM-Pir and it works properly as before. I am using mode 4 (HDMI CEC) and the monitor responds as expected. Thanks very much for the quick response! You guys are a real credit to this open source project!

[bugsounet]

@Freddy_boy perfect !

You understand now why i prefer works alone :D

I repeat again … If someone have the time to maintened this new module,
I will add a contributor access :)

@sdetweil: this module can be referenced on the third party module page ;)

[sdetweil]

@bugsounet sure give me access