Modifying the Config File

[sdetweil]

@jimb all the parms to a module go inside the modules
config:{} section

things to the left of : do not need quotes
things to the right of : do not need quotes if they are true/false, or a number

otherwise they need quotes. single or double doesn’t.mattet as long as both ends are the same.

also for each.parm you add, it needs to tell the interpreter if there is more after it. do this by adding a trailing comma

the apiVersion Parm

should look like this

{
   module:"weather",
   position mmmmm , 
    config:{
            apiVersion:3.0,
             whatever other parms
     }
}

[jimb]

Sam, I seem to be deeper in the weeds. After adding the apiVersion:3.0 parameter just below the config identifier in the config file -

running dev displays the following error-

Uncaught SyntaxError: Unexpected identifier 'weather identifie ‘weatherProvider’

and the config file blows up.

Do I need to add this on some other line?

[sdetweil]

@jimb after the config: for the module

[jimb]

Sam, that’s where I put it. I can’t cut and paste here because I’m on a different computer than the Pi.

[sdetweil]

@jimb said in Modifying the Config File:

Sam, that’s where I put it. I can’t cut and paste here because I’m on a different computer than the Pi.

turn on ssh, and install the bitvise or winscp ssh clients

then you can do everything from your PC. it’s SOOOOO much better

[jimb]

Sam , After adding the commas to the end of the version Iine I ran it with the check on the config file- All OK. I ran MM in Dev mode and now am getting a 401 error when it attempts to load the openweather resource files. So I seem to not be passing the version or ID string>

[sdetweil]

@jimb can you show the config for the weather module…

[jimb]

Sam, as a last resort (operating from 2 computers) I attemped to take a picture with my phone and copy that here. No luck. I hear you about working from my PC on the pi, but beyond my experience level. I could try and copy to another place or system?

[sdetweil]

@jimb posting your pic is the third icon from the right above the message editor

[jimb]

Sam, I get an error when trying to copy the file. Does it need to have a particular extension?