Apply color to future events in CalendarExt3

[sdetweil]

Another question. When did you install ext3

You DID run npm install the that module folder right?

[kkmirr04]

@sdetweil

I believe ext3 was one of the first modules I installed when I started everything this weekend. I do remember having some errors so theres a good chance I messed something up. I just ran npm install again and it processed fine, but no changes on the functionality.

Would it make sense to delete out the folder and try downloading / configuring the module again?

[sdetweil]

@kkmirr04 no, there was a fix a couple weeks ago, but if you just loaded it, should be fine

Can you add waitFetch:20000,

To the EXT3 module config

[sdetweil]

@kkmirr04 can you try release 2.36 just released.

[kkmirr04]

I tried adding the waitFetch and updating and no changes on my end. Do you think doing a clean install might be the next best step?

[sdetweil]

@kkmirr04 can you show the default cal and ext3 on the same page. With the same events.

Can you remove the calendarSets from the ext3 config

npm install in the ext3 module folder is enough

[kkmirr04]

@sdetweil Here is the events with the calendar

Remove the calendar sets and then run npm install again? I did see there is an update for my NPM - should i do that update too?

I also just noticed theres an error with CalExt3 when I close MM

[sdetweil]

@kkmirr04 thanks. I will try to test this out in a little bit

No, ignore the npm message

Yes, we found a bug in MagicMirror when looking for module updates. No harm done

[sdetweil]

@kristjanesperanto

can you explain this? the default cal shows colored, but Ext3 does not

I can duplicate, text not colored in Ext3

but pop is all colored.

[sdetweil]

@kkmirr04 on your second cal instance not showing

can you show the config, xxx out the cal url…

I am using pages, with ext3 on diff and cal on diff without problem… (except for ext3 color)