Problems with installing the Mirror new

[Hakupapa]

Thx for the answer. I attempted a little bit and I found the problems.
The biggest problem was the new but cheap 128 GB card. I had also problems while starting. That seems to be also the problem for other Installations.
The error in my first thread is not important. I used another smaller sd card and I got the error too but the mm works allright. So the problem seems to be solved.
Greetings from Hakupapa

[MarkV]

I got the same problem.

Before the update i had a MM with three extra modules, namely:
MMM-AssistantMk2
MMM-NotificationTrigger
MMM-Hotword

I also had teamviewer installed.
Everything worked fine.
I had the update message an i did the git pull && npm install

Didn’t had any updates during the update.
After the update i tried to start the mirror the normal way and i got the error like it’s mentiont at the beginning of this topic.

What’s causing this and how to correct it?

[A Former User]

Usually that case is caused by multiple execution of MM.
“pm2 stop mm” then “pm2 start mm” Or just reboot.

[MarkV]

@sean
thanks for the reply.
I don’t use pm2, i’m starting the mirror with “DISPLAY=:0 npm start”

To be sure i tryed the “pm2 stop mm” but like suspected i’m getting the “bash: pm2: opdracht niet gevonden” message.

[MarkV]

@sean
Your comment about multiple executions of mm got me thinking.
before the update i started the mirror. “pm2” didn’t worked and the mirror was shutdown, through ctrl+c.

So i did a restart of the pi and… now it works :-D

So the sollution (for me in this case) was restarting the pi, so it forgets the instance of mm :-D