I have disassembled the monitor and have seen that I can’t give the signals per gpio.

It’s a serial connection and I can’t simulate the protocol.
So, is it possible to use the LCD Screen?
It’s a m240hw01 v2

@schlachtkreuzer6 said in Monitor Samsung P2470H at home:

@fox maybe you can hack the soft buttons, and emulate them with the pi over gpio pins, write some code …

Good idea this could work. Even when the brightness / contrast is adjusted i need only P_ON/OFF, and i can put a signal on the GPIO Pin when the raspi boots, soldered parallel on the wire.
Thx for this idea!

Ok, i posted in the thread, lets see the progress.

Another thing is, my monitor has a touchpad connected with flat wire to the frame
I am just wondering how the raspi could even switch the monitor on or how i will control the Magic Mirror ;)

Thx first of all thx @Goldjunge_Chriz

When will it be ordered?
I would also like to order 70cmx40cm with polished edges.
Location: 86830 / Schwabmünchen

@schlachtkreuzer6 said in Monitor Samsung P2470H at home:

@fox https://forum.magicmirror.builders/topic/1011/two-way-mirror-order-in-germany/155

thx, just found it. But ~9m² away from order :-(. And

• http://glas-per-klick.de/spiegel-antikspiegel/spionspiegel.html
• http://myspiegel.de/ (not very good references…)
  https://forum.magicmirror.builders/topic/756/where-to-get-cheap-acrylic-mirror-from-in-germany/2

Thank you @broberg, i just started to disassembly it. Looks quite thick, so i need to make a big frame.

Next step will be the frame and look for a appropriate mirrorsupplier in germany

Hello,
i have read today the first time from this project :). So its my first post.
I want to start direct so i found the mentioned monitor in my cellar.
Is it suitable? Any ideas or experiences?

Best regards