Read the statement by Michael Teeuw here.
Monitor Samsung P2470H at home
-
-
@schlachtkreuzer6 said in Monitor Samsung P2470H at home:
@fox https://forum.magicmirror.builders/topic/1011/two-way-mirror-order-in-germany/155
thx, just found it. But ~9m² away from order :-(. And
-
We are not 9m² away from being able to order, it will just get cheaper with more than 20m². (There was an update to the conditions)
From what I understand, ordering is possible with the current amount already. -
Ok, i posted in the thread, lets see the progress.
Another thing is, my monitor has a touchpad connected with flat wire to the frame
I am just wondering how the raspi could even switch the monitor on or how i will control the Magic Mirror ;) -
@fox maybe you can hack the soft buttons, and emulate them with the pi over gpio pins, write some code …
-
@schlachtkreuzer6 said in Monitor Samsung P2470H at home:
@fox maybe you can hack the soft buttons, and emulate them with the pi over gpio pins, write some code …
Good idea this could work. Even when the brightness / contrast is adjusted i need only P_ON/OFF, and i can put a signal on the GPIO Pin when the raspi boots, soldered parallel on the wire.
Thx for this idea! -
Remember, the pi GPIOs can only handle 3V3. Check the voltage of the monitor buttons with a multimeter before soldering. You will likely need a level shifter.
-
I have disassembled the monitor and have seen that I can’t give the signals per gpio.
It’s a serial connection and I can’t simulate the protocol.
So, is it possible to use the LCD Screen?
It’s a m240hw01 v2 -
@fox It’s possible. If you configure your Pi to turn off the signal to the HDMI port, the monitor should shut off automatically. It should remain off until it detects a signal again, whereupon it will turn itself back on.
The MotionDetection module can do this for you with a Raspberry Pi camera. Otherwise, there is a module for using a PIR sensor.
