Read the statement by Michael Teeuw here.
230V in the naked monitor
-
@Jopyth said in 230V in the naked monitor:
doesn’t every monitor have the power supply inside somewhere?
Mine has an external power supply like those for laptops.
So I don’t have to remove the cover of the thing that converts 230 V to whatever.
I was looking for this feature to be more flexible in terms of heat prevention. -
@done Ok, in this case I have no idea. But if it is about the heat, I would probably prefer a hot thing over an electrocuting thing around my walls and the mirror.
-
Do you have got a picture ?
Normaly the metall which you can touch (even after removing the plastic shell) should have no contact with high voltage, as far as i know. The powersupply is normaly in an isolated shell because otherwise your screen will be rosted ;-) The other thing is the heat which leaves the monitor espacially with an internal power supply - anything higher than 45-50°C i would not accept especially when you think about the other parts of your mirror.
-
Thanks for your ideas!
@Jopyth mine looks quite a lot like yours. I took some photos and will post them on the weekend, but I won’t have any time this week.
I also had the idea to check with the multimeter, but I didn’t know what exactly to connect to.
I know that theoretically the metal shouldn’t carry a high voltage and be grounded anyway, but I still fear that something bad might happen, especially when the already-old monitor ages even further (I know, nobody can guarantee anything, but still it’s good to discuss the matter)
Heat is another problem I didn’t think of at all yet, I’ll check that as well when I have time. -
Alright, here’s the picture
I checked with a multimeter, the whole case is connected to ground. That won’t be a problem then.
But the monitor gets HOT, I can barely touch the part on the back that has little holes in it. I really need to think of a solution to that.
