MM Standby loop _ Unable to access raspberry

Nneuland

I hope that I have enabled SSH on the raspberry. I think I had.
I have yet to try accessing the pi yet from SSH, but fingers crossed.

Yes. I am using PIR as a motion sensor. I have tried detaching the PIR with no luck.

George

@nneuland , If the PIR sensor does not work, the mirror does not work.

Nneuland

I believe the PIR is working fine. Just not sure why the HDMI connection is immediately lost after the mirror has loaded.

Wouldn’t disconnecting the PIR from the Pi correct this?

sdetweil

@nneuland the pir module has turned off the hdmi port… (as if no motion, time to sleep)

Nneuland

Not sure how that happened out of nowhere. I should delete the PIR module through ssh to see what’s going on then?

Unless I can modify the config file through the remote app. Not sure that’s safe though.

N

sdetweil

@nneuland things work reliably until they dont!
if u can thru remote, just add disabled:true,
after the pir module name line

Nneuland

@nneuland
Nothing truer has been said. I’ll give it a go

Nneuland

Deleting PIR from the config through the remote worked!

Thank you Sam.