PI Zero module issues for this beginner

sdetweil

@wagon40 you should use my installation script… it does it all…
see here https://github.com/sdetweil/MagicMirror_scripts/blob/master/run-start.sh

use the desktop version of the pi 0… stretch or buster… jessie is too old

what modules

what is installed is folders in ~/MagicMirror/modules
what is being used , see the ~/MagicMirror/config/config.js, and each module: statement
where disabled is not specified or disabled: false

nano is the commandline editor

ctrl-o to save the file
ctrl-x to exit
ctrl-w to search the file

I had to manually add the configuration I found on the My-commute page so is that normal to have to enter in configuration to the config.js?

yes. u install the code, then have to update the MM config to actually use it

wagon40

@sdetweil thank you for the quick reply. I will try your download tomorrow if I get a chance and hopefully have better luck.

sdetweil

@wagon40 to install MM again, you will need to rename the current folder out of the way

do this

cd ~
mv MagicMirror  MagicMirror.save

wagon40

can you send me the direct script to place in the command line to load your script? I have tried a few bash $( bala bal bal) and im not getting much luck.

I tried to follow this https://forum.magicmirror.builders/topic/9386/installing-on-a-pi-zero/72
but of course it wont start. screen goes to sleep and it only starts for a minute then goes to desktop.
I installed buster with desktop.

sdetweil

@wagon40 from the page I referenced

bash -c "$(curl -sL https://raw.githubusercontent.com/sdetweil/MagicMirror_scripts/master/raspberry.sh)"

you can do that over ssh, or on the pi monitor terminal session

it will prompt you about autostart with pm2 and turning off screensaver

wagon40

@sdetweil
all was going well until the dependencies stopped it. tired to send the code using </> or :: but it blanks out the submit button?

wagon40

@wagon40

npm WARN grunt-stylelint@0.13.0 requires a peer of stylelint@^12.0.0 but none is installed. You must install peer dependencies yourself.

npm ERR! code ELIFECYCLE
npm ERR! errno 1
npm ERR! electron-chromedriver@1.8.0 install: `node ./download-chromedriver.js`
npm ERR! Exit status 1
npm ERR!
npm ERR! Failed at the electron-chromedriver@1.8.0 install script.
npm ERR! This is probably not a problem with npm. There is likely additional logging output above.

npm ERR! A complete log of this run can be found in:
npm ERR!     /home/pi/.npm/_logs/2020-02-05T21_24_22_985Z-debug.log
Unable to install dependencies!

sdetweil

@wagon40 hm… I don’t see that on my pi 0…

And electron is optional, so there should be no need for chrome driver

wagon40

Same issue I had with the other download. any suggestion?


npm ERR! code ELIFECYCLE
npm ERR! errno 1
npm ERR! electron-chromedriver@1.8.0 install: `node ./download-chromedriver.js`
npm ERR! Exit status 1
npm ERR!
npm ERR! Failed at the electron-chromedriver@1.8.0 install script.
npm ERR! This is probably not a problem with npm. There is likely additional logging output above.

npm ERR! A complete log of this run can be found in:
npm ERR!     /home/pi/.npm/_logs/2020-02-05T22_31_04_266Z-debug.log

sdetweil

@wagon40 I will have to look. It will be a couple hours. Have grandson now