[Electron] display en screen after installing MMM-PIR-Sensor

RIKKO14

Yes, the screen actually powered off

RIKKO14

And I forgot to not the IP adress of my py, so I can’t use ssh now…
Pffff, I’m not lucky, every modules I want works instead of the PIR module…

RIKKO14

If i find my IP adress, Can you give me the commands to delete the problem ?

sdetweil

@RIKKO14 if u didn’t turn on ssh, it isn’t on, so can’t use it anyhow. look in your router to see what addresses were given out…

I do that quite often, then fix/reserve the address so I don’t have to remember

RIKKO14

ok, i find my IP adress (I’ve wrote it in excel file with some commandes i use) and I connected in SHH with putty,
thanks for your help to delete the commandh whose powered off my screen

RIKKO14

below my pm2 logs,
If that can help you…
https://www.cjoint.com/c/JHvqsqJ1QTT

RIKKO14

If it can help you this is my pm2 logs : https://www.cjoint.com/c/JHvqsqJ1QTT

sdetweil

@RIKKO14 looking at… hard to tell
do

pm2 stop 0
pm2 flush 
pm2 start 0

the will throw away the old logs…

RIKKO14

I do this, the problem still here…

sdetweil

@RIKKO14 it just makes the log easier to read. please post it again