[Electron] display en screen after installing MMM-PIR-Sensor

[RIKKO14]

If i find my IP adress, Can you give me the commands to delete the problem ?

[sdetweil]

@RIKKO14 if u didn’t turn on ssh, it isn’t on, so can’t use it anyhow. look in your router to see what addresses were given out…

I do that quite often, then fix/reserve the address so I don’t have to remember

[RIKKO14]

ok, i find my IP adress (I’ve wrote it in excel file with some commandes i use) and I connected in SHH with putty,
thanks for your help to delete the commandh whose powered off my screen

[RIKKO14]

below my pm2 logs,
If that can help you…
https://www.cjoint.com/c/JHvqsqJ1QTT

[RIKKO14]

If it can help you this is my pm2 logs : https://www.cjoint.com/c/JHvqsqJ1QTT

[sdetweil]

@RIKKO14 looking at… hard to tell
do

pm2 stop 0
pm2 flush 
pm2 start 0

the will throw away the old logs…

[RIKKO14]

I do this, the problem still here…

[sdetweil]

@RIKKO14 it just makes the log easier to read. please post it again

[RIKKO14]

hre it is :
https://www.cjoint.com/c/JHvrPBCBgZT

[RIKKO14]

and this one (because i don’t if it it change something) : https://www.cjoint.com/c/JHvrUegIVzT after the command :

pm2 stop 0
pm2 flush 
pm2 start 0

and after only pm2 logs --lines=100

without pm2 status and pm2 stop 0