Read the statement by Michael Teeuw here.
[Electron] display en screen after installing MMM-PIR-Sensor
-
@RIKKO14 and u don’t need to reboot. just use the pm2 commands
pm2 restart 0
-
I do this, MM reload but now after 2-3 secondes the screen turn off, GA with Jarvis works in background but i can’t find the screen of MM, if i do Ctrl + M
nothing is happening, there, I’m completely stuck…, I unplugged but the problem stay here… -
@RIKKO14 is the screen actually powered off? did u enable ssh to get into a terminal window if desktop/mm has trouble?
if so I can issue commands there to turn on display tvservice or dpms…
I don’t use PIR, lots of troubles.
-
I dont use ssh, only command on the py.
Instead of that, i think the py cut the power to the screen because the led of my screen is yellow like power off and not blue like something displayed. -
Yes, the screen actually powered off
-
And I forgot to not the IP adress of my py, so I can’t use ssh now…
Pffff, I’m not lucky, every modules I want works instead of the PIR module… -
If i find my IP adress, Can you give me the commands to delete the problem ?
-
@RIKKO14 if u didn’t turn on ssh, it isn’t on, so can’t use it anyhow. look in your router to see what addresses were given out…
I do that quite often, then fix/reserve the address so I don’t have to remember
-
ok, i find my IP adress (I’ve wrote it in excel file with some commandes i use) and I connected in SHH with putty,
thanks for your help to delete the commandh whose powered off my screen -
below my pm2 logs,
If that can help you…
https://www.cjoint.com/c/JHvqsqJ1QTT
