MMM-DHT-Sensor : black screen : problem of electron's version number

sdetweil

@RIKKO14 how to do what?

RIKKO14

to install electron rebuild ?

sdetweil

_@RIKKO14
cd ~/MagicMirror
npm install electron-rebuild

cd ~/MagicMirror/modules/??? module name
node ~/MagicMirror/node_modules/.bin/electron-rebuild

RIKKO14

it’s ok for MMM-DHT-Sensor, thank you so much
for pm2 i will see tomorrow .

RIKKO14

today I reinstalled MMM-Google Assistant, MMM-Assistant2Display, MMM-GABackground.
After several reboots pm2 finally starts automatically without doing the procedure you indicated to me above: weird but so much the better … (
should I even have your procedure done ?)

On the other hand I had to remove with-BackgroundStatus.js from the GoogleAssistant recipe (too bad) because the responses are slower and the movements of the “Jarvis” logo are not smooth (however I have Raspberry 4 B 2Go).

Since my new installation I still find that the responses to “Jarvis” commands are either long or nonexistent.
I checked if openGL is working and the answer is: direct rendering: Yes

I also installed "with-radio_fr.js" recipe but when I say “Jarvis mets RTL” or “Jarvis mets … sur youtube” the command starts (radio or youtube) but if I then say “Jarvis” for stopping, Jarvis command does not start, I have to close the MM window to stop it.

a few times after executing “Jarvis, quel temps fait t’il ?” command for example the window account.google.com/o/oauth2… opens and ask me to confirm the account used it, didn’t do that to me before

well too often I have to change the plughw to 1 or 2 in config.js, is there something to do ?

thank you for your help on these different questions?

sdetweil

@RIKKO14 @Bugsounet

RIKKO14

with arecord -l I have :

```pi@raspberrypi:~/MagicMirror $ arecord -l
**** Liste des Périphériques Matériels CAPTURE ****
carte 1: USB [WordForum USB], périphérique 0: USB Audio [USB Audio]
  Sous-périphériques: 0/1
  Sous-périphérique #0: subdevice #0

so the capture card is : 1, however sometimes I have to put 2 for “Jarvis” to start

I do this too :

responseConfig: { 
  useNative : true , 
  playProgram : "mpg321" 
}

but I often have to call “Jarvis” several times for him to answer

sdetweil

@RIKKO14 what microphone are you using?

does it work better w a different hotword?

RIKKO14

this one :
https://fr.aliexpress.com/item/4000472738470.html?spm=a2g0s.9042311.0.0.27426c37Cmejmg

“Jarvis” responds well even at 3 or 4 meters

sdetweil

@RIKKO14 eh, you said doesn’t respond