RPi5 running hot

[S374n]

My Pi5 has a on chip fan and it was running 75 inside the box attached to the monitor in the back.
I added external little fab on top of my enclosure to extract the hot air and it dropped the temp to 60.
Moved it 1 inch away from the monitor back panel and the temp now is 55 all the time with screen on and 44 during the night when the screen off.

[videogame95]

You shouldn’t run any raspberry pi 5 without cooling fan on top it will break if run it without fan installed
Buy fan

[mvrlogins]

I have ordered a fan/cooler

But anyone have any insight into whethere the processes I listed are over running?

[sdetweil]

@mvrlogins if you stop MagicMirror what is the temp?

[mvrlogins]

@sdetweil said:

@mvrlogins if you stop MagicMirror what is the temp?

It drops to 50C in a few min

[sdetweil]

@mvrlogins said:

The EmbendURL modules only display on demand on a seperate page

what do you mean by separate page?
MagicMirror does not have pages, it has logical groupings of content, some shown together, others hidden (this is MMM-pages, MMM-Carousel, MMM-ModulesGroupsRotation, MMM-ProfileSwitcher, etc)
so even if not shown, some content could still be generated (Embed/iFrame) , they don’t know they are hidden

if you run ps -ef you can see the commandline used to launch each process.

you say you have a 1 gig pi5, but mem reports as 2gig.

but you are over physical, and swapping. which takes cycles.

I would suggest, disabling module at a time
add

disabled:true, 

after the module:name… line

and rerun to see what the effect is. what are the embed modules showing? active content, graphs, images??

[mvrlogins]

@sdetweil said:

@mvrlogins said:

The EmbendURL modules only display on demand on a seperate page

what do you mean by separate page?
MagicMirror does not have pages, it has logical groupings of content, some shown together, others hidden (this is MMM-pages, MMM-Carousel, MMM-ModulesGroupsRotation, MMM-ProfileSwitcher, etc)
so even if not shown, some content could still be generated (Embed/iFrame) , they don’t know they are hidden

if you run ps -ef you can see the commandline used to launch each process.

you say you have a 1 gig pi5, but mem reports as 2gig.

but you are over physical, and swapping. which takes cycles.

I would suggest, disabling module at a time
add

disabled:true, 

after the module:name… line

and rerun to see what the effect is. what are the embed modules showing? active content, graphs, images??

The EmbedURL module shows a WebRTC video. The page is hiddent and called on demand (not regular rotation).

I thought that the module would not continue to stream the video when hidden. I guess this is the problem, since it does continue

[mvrlogins]

Instead of using pages to hide the module, I guess I could use MMM-Remote-Control to enable/disable the EmbedURL module? That would stop the streaming?

[sdetweil]

@mvrlogins i think runtime enable/disable just changes its visibility. there are no apis to add/remove modules from the DOM.
the disable at startup skips adding it as a runtime module… which is completely different

[mvrlogins]

@sdetweil

Thanks

I’ll have to find another way to stop the streaming while the page is hidden