MMM-PIR-Sensor - White Screen

Bangee

@samydp did you maybe reneamed this folder:
modules/MMM-PIR-Sensor/node_m odules <- is there a space in this name??
you’ll have to remove this

samydp

I have the folder node_modules in MMM-Pir folder .
should I delete the folder?

Bangee

Can you post a printscrenn from this folder?
you can also try to go use these commands:

cd ~/MagicMirror/modules/MMM-PIR-Sensor/
git pull
npm rebuild

samydp

Bangee

That looks fine.

Did you try to remove your folder MMM-PIR-Sensor an reinstall the modul?

samydp

yes but i dont have the folder node_modules in the PIR Folder :/ i have install WrinPi but nothing works :/

Bangee

ok so lets go step by step:
cd ~/MagicMirror/modules/

now we will remove the PIR folder:
rm -rf MMM-PIR-Sensor

and from here, we’re going to reinstall the MMM-PIR-Sensor modul:
git clone https://github.com/paviro/MMM-PIR-Sensor.git
cd MMM-PIR-Sensor

run the following cmd here:
npm install and wait, this can take a few minutes.

Now you’ll have to add pi to gpio
sudo useradd -g pi gpio

and reboot your Raspi:
sudo reboot

You’ll have to connect your PIR Sensor the right way with your Raspi.
I’ve connected my PIR Sensor on the following Pins:
GPIO
I’ve got a Pi2 and use Pin 2 for power, Pin 6 for Ground and Pin 15 for Data.
– correctin grn pin

PIR Sensor

and dont forget to add the config :-)

samydp

you are the best !! i dont become no a with screen !

but the sensor dont work

i have
vcc: Pin 2
Data: Pin 7
Ground: Pin 6

and my config in the config and MMM-PIR-Sensor data is:

}
{
        		module: 'MMM-PIR-Sensor',
        		config: {
			sensorPIN: 7,
			relayPIN: false,
			powerSaving: true,
			relayOnState: 1,
            }
            },

the sensetiv is max and the time is min

Note from admin: Please use Markdown on code snippets for easier reading!

Bangee

If you use pin 7 in your config its nr 4

You have to use the gpio nr.

samydp

Thank you it works fine !!