MMM-FRITZ-Box-Callmonitor

[ostfilinchen]

@Jopyth: that doesn’t work. The mirror Shows me the Number, not the Name of the caller.

[Jopyth]

@ostfilinchen Can you add showContactsStatus: true, in the config, and see if it successfully loads your contacts? Either a small warning sign should appear after you restart your mirror, or a number showing how many contacts are loaded.

If the contacts load correctly, please look at the format your numbers are in the phonebook, e.g. are they like +12 (345) 678901 or 0012345678901… (do not post the real number)? I have experienced some problems with certain formatting as well, however have not had time to fix it in the code, instead I replaced my numbers in the FRITZ!Box, and always used the format 0123 4567891.

If there is a warning sign, please have a look at the logs (if you start it with pm2 you can do pm2 logs --lines 100 mm) and search for an error related to the Callmonitor.

[ostfilinchen]

@Jopyth if i Set the Contact Status to true, nothing happens. There’s no Icon and the logs displays no error.

[Jopyth]

@ostfilinchen You might have on older version can you try to use git pull and see if it updates (note: you must do this inside the MMM-FRITZ-Box-Callmonitor folder. Also you can check the date of your version with git show, it should show this:

commit 9a35b1a74811a2e7c31edb35d59bab010dd5f991
Merge: 08633e0 bfee1e5
Author: Paul-Vincent Roll <paviro@me.com>
Date:   Fri Sep 23 11:26:47 2016 +0200
[...]

[ostfilinchen]

this output i have also…

must i activate the vcard-option to show how many contacts loaded?

[Jopyth]

@ostfilinchen Please check your config again. Is your password empty (i.e. the empty string password: "")? That would not work, but otherwise it should. I did a clean install and this config works for me:

{
	module: 'MMM-FRITZ-Box-Callmonitor',
	position: 'bottom_right',
	header: "Recent calls",
	config: {
		username: "EXAMPLE_USER",
		password: "EXAMPLE_PASSWORD",
		showContactsStatus: true
	}
},

Result:

If I type a wrong password, it shows an error:

[...]
config: {
	username: "EXAMPLE_USER",
	password: "WRONG_EXAMPLE_PASSWORD",
	howContactsStatus: true
}
[...]

If you can not see either of these results, and you say your version is up-to-date, then I am little bit out of guesses. Maybe you can try complete removing the module, and downloading it again?

[ostfilinchen]

i have an fresh Installation and i don’t get this Output. If i set vcard to true, then it Shows me the little book with spinning arrows. The Password and user is set.

[Jopyth]

@ostfilinchen Please check if your option is German passwort (does not work) or password (English).

[ostfilinchen]

@Jopyth it’s password

[Jopyth]

@ostfilinchen Damn. Because I saw this in your first post. :( This was my last hope.

Edit: Can you post the output of git status one more time? Just to make sure everything is fine with your module.