Changing icons of the modules Current Weather and Weather Forecast

[Manu85]

@sdetweil
I use RealVNC Viewer and when I do ctrl-shift-i I have this window which opens I click at the top left and with my mouse I browse the lines, I have several lines with weather but when I click on them none opens another window

[sdetweil]

@Manu85 yes, good

click the arrow pointer in the red box
then move the mouse over the weather content in the left side page, it will select the content as it goes… make sure the entire weather content is selected
then click

[sdetweil]

@Manu85 when its auto selected it will look like this

[Manu85]

@sdetweil
it’s complicated, I can’t have a selection like you, I selected the icon at the top with the cloud and the moon I have lines that have changed on the table on the right but I don’t have another window that opens

[sdetweil]

@Manu85 i’ve never done this over vnc…

the right panel is just hidden on your vnc screen. you might be able to scroll right

if you are in the same house as MM, you dont need to use vnc to view the page

as long as your config.js says

address:"0.0.0.0",
ipWhiltelist:[],

then any machine on the same network can attach, so you can do this from your windows machine too… and do the debug from there as well

[Manu85]

@sdetweil my js config says that!

fig = {
	address: "localhost", // Address to listen on, can be:
	                      // - "localhost", "127.0.0.1", "::1" to listen on loopback interface
	                      // - another specific IPv4/6 to listen on a specific interface
	                      // - "", "0.0.0.0", "::" to listen on any interface
	                      // Default, when address config is left out, is "localhost"
	port: 8080,
	ipWhitelist: ["127.0.0.1", "::ffff:127.0.0.1", "::1"], // Set [] to allow all IP addresses
	                                                       // or add a specific IPv4 of 192.168.1.5 :
	                                                       // ["127.0.0.1", "::ffff:127.0.0.1", "::1", "::ffff:192.168.1.5"],
	                                                       // or IPv4 range of 192.168.3.0 --> 192.168.3.15 use CIDR format :
	                                                       // ["127.0.0.1", "::ffff:127.0.0.1", "::1", "::ffff:192.168.3.0/28"],

[sdetweil]

@Manu85 yes, that means only apps INSIDE the same machine can connect

change

address:"localhost",  // means only inside same machine

to

address:"0.0.0.0",  // alows any device on any network this machine is connected to to connect

then also the whitelist

comment out the current line

// ipWhitelist: [ 127.....

and add a new line

   ipWhitelist:[],  // don't filter any connecting client addresses

then restart mm…
if you know the ip address of the pi (and u had to use it for vnc)
then open a tab on you pc browser and do

http://MM_ip_address????:8080

[Manu85]

@sdetweil ok it’s done and it’s actually much better

[Manu85]

@sdetweil by doing ctrl shift i my window opened like this

[sdetweil]

@Manu85 yes, it just has the developers window docked on the bottom…

helps when trying to do layout… nothing changes

if you want it docked on the right, use the … menu top right of the dev window and change it…