Read the statement by Michael Teeuw here.
Independent display controller based on PIR sensor.
-
@Beh i see thx! maybe it’s better to use your one to somehow bypass these settings which are a bit frustrating. i did’t really get the systemd option (i am new) but as i understood it’s like a crontab, correct?
-
@bibi No, it’s more like having it added to the autostart (like on windows). Then it’s running as a service in the background, which can be controlled via
systemd’ssystemctlcommand. -
hi @Beh ! unfortunately your module is not working for me :( could you please help me to figure out why? i have bought the same PIR sensor and plug it in the gpio 14 (physical pin 8) thx!
-
it’s solved ;-) thx anyway
-
@beh hi! i was wondering if there was an easy way to add a fading effect when the mirror goes to sleep and wake up? would be interesting in this as well? thx
-
Hi @bibi, I hope, I understand that right.
I don’t think that this is very easy. Because the script just turns the HDMI port of the RaspberryPi to on and off. So a fading effect wouldn’t be quite easy I think
-
@Beh i understand this. No problem and thx for reply! :)
-
@bibi hi can anyone help me with screenshots the file path where to enter the below commands to start it at boot time
cp ./pir_sensor.service /lib/systemd/system
systemctl daemon-reload
systemctl start pir_sensor.service
-
@shashank hi! unfortunately you will not find the cmd line in the github to enable the service at boot time. As far as i have checked, the systemd should already run at boot but for strange reasons it was not the case for me. Therefore, i had to issue the command : sudo systemctl enable pir_sensor.service
good luck! -
Ok, maybe I forgot that in the readme file, or it worked straghtaway on my Pi.
I’m going to addsudo systemctl enable pir_sensor.serviceto the readme file!thanks for the hint :)
