@Jopyth said in [MMM-PIR-Sensor] Install failing:

@Makradon Nope, definitely not the same numbering.

Now I’m confused.

5V is Pin 2
Ground is Pin 6
I think that is right when you count like this:

http://www.elektronik-kompendium.de/sites/raspberry-pi/fotos/raspberry-pi-15b.jpg

And when you don’t change the pin in the config file it says SensorPin 22.
So which is the right pin in the pic above to connect the output of the PIR sensor that it works with this module?

Thanks for trying to help me.

I tried what you said. It always says “motion detected”.
I’m sure the wiring is right… I also use the dht22 sensor and that works perfectly fine. And the way you count the pins is the same… isn’t it?

I bought a new PIR sensor… but the problem is still there.

@kerijn said in [MMM-PIR-Sensor] Install failing:

@Jopyth This worked for me for the installation as well. Thank you! However, the sensor does not seem to do anything. How can I check whether the sensor is working properly?

I have the same problem

Hello.
I’m also interested in one of your mirrors. I’ll figure out the size that I need and then I’ll let you know in a few days. I’m from Germany too. Do you know how much shipping is? I’d like to go for a size around 0.6m x 1m. Thanks so far!