@Mykle1
It is not my intention to re-install on Zero but use my RPi3 installation via card swap. Reading your answer I understand this is not possible. When I enter “~/MagicMirror $ npm start” there is a segmentaion fault message shown.
A New Chapter for MagicMirror: The Community Takes the Lead
Read the statement by Michael Teeuw here.
Read the statement by Michael Teeuw here.
M
Offline
Posts
-
RE: Exchange SD-card RPi with Zero W
-
Exchange SD-card RPi with Zero W
MM installed on Raspberry Pi 3 works fine but when I take out the SD card and put it in a Raspberry Pi Zero W the MM will not start and reports there is something wrong within the config file. Is this a well known issue?
-
RE: Module update
Thank you for your advice, after following your instructions (git pull AND npm install) everything looks okay now and my mirror is up to date :-)
-
Module update
I’m afraid this is a newbie question but after long time searching and nothing found I need to ask. My MagicMirror shows there is an update for the MMM-Traffic module but I don’t know how to update this module. Does anyone have an advice or the correct SSH command to update?