@AAPS
(Raspi 3)
Just connect the PIR sensor Pins with three of these connector cables (female on both sides) directly to the GPIO pins on the PI, without soldering.

You need to know the pin assignments of your PIR sensor. I used:
(4) +5V
(6) GND (ground)
(32) GPIO12
i think you can also use (15) instead of my (32) then you don’t need to change the pin in the config file.

Hope that helps.

Hey @Jopyth,
yes I made it. It works, but only with one video. At the moment, I am changing the Podcast module to play two videos (with two buttons at the remote page), two or more timed donwloads, but that will take some time. If someone want to use the one Video Version i can send the files, or upload them on github?! I made most of the changes in the Remote-module.

I am looking for a development enviroment to develop faster than it’s possible with “serveronly”. Any suggestions?
Ah and one thing, could you tell me how to get these incons for the buttons on the Remote page? A “Play”-icon would be nice.

@AAPS
Yes that’s the right one.

@AAPS
(Raspi 3)
Just connect the PIR sensor Pins with three of these connector cables (female on both sides) directly to the GPIO pins on the PI, without soldering.

You need to know the pin assignments of your PIR sensor. I used:
(4) +5V
(6) GND (ground)
(32) GPIO12
i think you can also use (15) instead of my (32) then you don’t need to change the pin in the config file.

Hope that helps.

@Jopyth @roramirez exact. You are right. This is the Module I am using. But it will only start with a Hardwarebutton. So last night i added an extra menubutton to the Remote-Control, which will send the notification “BUTTON_PRESSED” to all modules (i hope also to the PodcastModule) and then the Video should start.
That’s the theory. But i ended at the point where the Notification will be send. I also have some trouble with the podcast video download. etc.

Anyway. I figured out 3 ways to realize the “Remote Start a Video”

1. use the Podcast-Module

• with the Tagesschau in 100 Sek RSS

2. use Iframe

• and the channel “project ambr” (just search “Tagesschau in 100 sekunden” on youtube), where the latest TS100s will be uploaded every time a new one is released
• here it’s possible to use autoplay, but i could not find a permanent link to the newest video of this channel

2. use Iframe

• and show the whole TS Website
• there the autoplay is ON by default
• negative points: you see the whole website around, when switching the iFrame off, while the video plays the sound will not switch off. Only the iFrame disappears. (logic cause it’s a visible switch)

ALL of them use the Remote to

1. switch the Iframe / podcast module ON
2. switch all other modules off
3. start the video either by notification or automated

Har. That’s sad. Then I need to check the possibilities by myself. I thought I just wait some time and the problem solves itself.

Hello @lolobyte,
that is exactly what i also wanted to do. Starting the Tagesschau or whatever with the “Remote-Control” module. Did you found a solution for your problem?