@clumsy_ninja trying again using an image hosting service: https://postimg.org/gallery/1lw67cdn2

Hey @Lobsta, the film wasn’t very hard to apply to glass. Took me, doing it for the first time, about 20 minutes and it didn’t look too horrible.

Images are not working well on this forum hey - tried to upload them again but no luck…

I’ve today finished the woodwork, with a lot of help from a friend that is experienced in weekend-woodwork. I don’t think it was any harder with glass than it would have been with acrylic. Certainly heavier though. I suspect the film would just as well with acrylic…

Thanks @zydecat74 - I’ve tried with the film you suggested ($45 from Bunnings) + a normal piece of glass ($22 from a local glass shop). It works like a beauty.

You will also need an application tool (yellow thing in the photo), a very sharp knife, a ruler (ideally longer than the one I used) and baby shampoo to mix with water and spray on the glass/film to apply it.

Photos of stuff and the result. All that is left for me now is to make the frame - but it is starting to look achievable now.

The film
![0_1475966543600_Energy saving film copy.jpg]
![0_1475966558698_Energy saving film 2 copy.jpg]

Tools
![0_1475966573010_Other tools copy.jpg]

Results (the film is inside)
![0_1475966586655_Result with film inside copy.jpg]

I shall try again (currently travelling for work) later this week and report back with more details…

G’day @BenRoe

when using your module (Raspberry Pi powered) I get the below message and nothing appears to work. If I comment out the MMM-SystemStats module config on config/config.js the other modules work again.

(node:2247) DeprecationWarning: sys is deprecated. Use util instead.

Any clues?

Cheers,
Tiago