Wow, such a crazy frame. Well done!

@Mykle1
Well deserved!

Oh bad. Good you found it and good it was not fault of Windows … errm Raspbian ;)

I just completed it

You could try to find out if your monitor supports CEC commands and use libcec to force your monitor going to standby instead. Downside is, that the screen takes longer to turn back on.

@H3L1o150
No, you need to edit the file node_helper.js in the modules folder
Currently you cannot define the pin and the sensor type in the config section. But I think this should be improved in a future release

You are looking for this: https://forum.magicmirror.builders/topic/286/regions :)

Try this.config.gesture_up instead

I never played around with this module. But I would use this:

{ module: 'MMM-Temperature-Humidity', position: 'top_right' }

And then you edit node_helper.js to set for DHT11 or DHT22 and the correct pin in ( )