MM Nightly Reboot Needed, PM2 ?

[cohron]

I have a finicky wireless here and need MM to reboot nightly to stay connected, otherwise MM loses the connection and never reconnects.
Can anyone help me set up a scheduled reboot script for my RPI? I have PM2 installed and running for auto-start but I dont see where it can reboot my RPI.

Many thanks.

[Mykle1]

@cohron

Have you done this?

Disable WiFi Power Save

Edit /etc/modprobe.d/8192cu.conf

sudo nano /etc/modprobe.d/8192cu.conf
Add the following lines

Disable power saving

options 8192cu rtw_power_mgnt=0 rtw_enusbss=1 rtw_ips_mode=1
For Raspberry Pi 3
Edit /etc/network/interfaces

sudo nano /etc/network/interfaces
Add the following line under the wlan0 section

wireless-power off
Reboot your PI

sudo reboot

That comes straight from here:
https://github.com/MichMich/MagicMirror/wiki/Configuring-the-Raspberry-Pi#disable-wifi-power-save

[cohron]

@Mykle1 I did but since i didnt have the Edit /etc/modprobe.d/8192cu.conf file, I’m running an rPI3b so I did the wireless-power off step bu it didnt seem to help or the problem is outside the raspberry.

I just found how to do a nightly reboot using crontab.
https://www.raspberrypi.org/forums/viewtopic.php?f=91&t=126106

[Mykle1]

@cohron said in MM Nightly Reboot Needed, PM2 ?:

I just found how to do a nightly reboot using crontab.

That worked for me and I have Pi3 b as well. Glad you found the script you were looking for. Good luck!

[cohron]

@Mykle1 curious, did you have the /etc/modprobe.d/8192cu.conf file already or did you create it? i just created it, just in case that does the trick too.

thanks again.

[Mykle1]

@cohron said in MM Nightly Reboot Needed, PM2 ?:

@Mykle1 curious, did you have the /etc/modprobe.d/8192cu.conf file already or did you create it? i just created it, just in case that does the trick too.
thanks again.

As it turns out, I do NOT have the 8192cu.conf file are all.
pi@Pi3:/etc/modprobe.d $ ls
fbdev-blacklist.conf ipv6.conf libpisock9.conf raspi-blacklist.conf
pi@Pi3:/etc/modprobe.d $
`
However, looking at the instructions again, it says:

For Raspberry Pi 3
Edit /etc/network/interfaces

sudo nano /etc/network/interfaces
Add the following line under the wlan0 section

wireless-power off
Reboot your PI

sudo reboot

It’s been some time since I set up my Pi but it’s obvious that I only did this portion of the instruction

[Mykle1]

@cohron

I was curious so I checked my /etc/network/interfaces file. It would appear I don’t have the edit we’re talking about, yet my wifi never drops. Here is the file:

interfaces(5) file used by ifup(8) and ifdown(8)

Please note that this file is written to be used with dhcpcd

For static IP, consult /etc/dhcpcd.conf and ‘man dhcpcd.conf’

Include files from /etc/network/interfaces.d:

source-directory /etc/network/interfaces.d

auto lo
iface lo inet loopback

iface eth0 inet dhcp

auto wlan0
allow-hotplug wlan0
iface wlan0 inet dhcp
wireless-essid XE1S3
wireless-key 5BBXXXXXX