Avoid "HDMI" splash screen on PIR control

[vongomben]

Re: PIR Sensor - Sleep LCD monitor

Hello.
I found this interesting topic on the forum, but couldn’t find a solution to the “HDMI” screen popping up whnever I turn on my Screeen device.

I’m using the standart board to use old Laptop screens.

Any advices?

[sdetweil]

@vongomben did you mean when u turn off?

this is the energystar compliance in the monitor that says “oh no!, input is turned off, I will power off soon”

no way to work around this. except to turn the monitor off
not many ways to do that

[cowboysdude]

@vongomben Mine does it too. It flashes a couple times then goes off.

@sdetweil is right… no way around that.

[vongomben]

@sdetweil ok.
I still have the remote from the board, will check if there is a standby function there.
Will update you here.

d

[sdetweil]

there is no solution, other than to find a monitor that doesn’t do it.

just about every display and tv shows some branding message during power on.

[sdetweil]

this why my sleep/wake module hides all the modules instead of turning the display off.

(and the fact that I can’t get it to turn off by software. but I can turn it on…)