Read the statement by Michael Teeuw here.
Avoid "HDMI" splash screen on PIR control
-
Re: PIR Sensor - Sleep LCD monitor
Hello.
I found this interesting topic on the forum, but couldn’t find a solution to the “HDMI” screen popping up whnever I turn on my Screeen device.I’m using the standart board to use old Laptop screens.
Any advices?
-
@vongomben did you mean when u turn off?
this is the energystar compliance in the monitor that says “oh no!, input is turned off, I will power off soon”
no way to work around this. except to turn the monitor off
not many ways to do that -
@vongomben Mine does it too. It flashes a couple times then goes off.
@sdetweil is right… no way around that.
-
@sdetweil ok.
I still have the remote from the board, will check if there is a standby function there.
Will update you here.d
-
there is no solution, other than to find a monitor that doesn’t do it.
just about every display and tv shows some branding message during power on.
-
this why my sleep/wake module hides all the modules instead of turning the display off.
(and the fact that I can’t get it to turn off by software. but I can turn it on…)
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login