Auto on/off of the TV (not the Pi)?

MechMatt

Hey Everyone,

I was wondering if anyone had any ideas on a good way to have the monitor/tv turn on and off automatically at specific times. I know there is an auto on/off module for the raspberry pi, but I was thinking this for the screen itself.

My mirror is set up with a non-smart tv that doesn’t have any options for auto on and off. I have a logitech harmony remote that I haven’t had a chance to try yet , but some quick googling makes me think it doesn’t have the auto start functions. Anyone have any (preferably cheap) ideas?

zombi27

Hi,

@paviro just did want you probably want

https://github.com/paviro/MMM-PIR-Sensor

With this you can either turn of the HDMI signal (maybe your monitor goes to sleep then), or you can cut off the power signal of your monitor with a simple relay.

zombi27

*just did what you probably want (typo)

@paviro / @MichMich: am i not allowed to edit my reply? there is a 120sec time limit for editing?

paviro

@zombi27 Yes might consider changing this to ten minutes or so

Mitchfarino

@zombi27 @paviro I’m wanting to use the camera/facial recognition to do this - but haven’t even looked at it yet.

Work/Family life has prevented me recently.

Slow and steady wins the race

MechMatt

@zombi27 oh awesome i will have to check this out

KirAsh4

@zombi27, yeah, @paviro wants to make sure that once you post your message, you are 100% committed to it. There will be no going back to change your post, or reply. You don’t get to pass GO and collect twice.

paviro

@KirAsh4 @zombi27 changed it to ten minutes Should be enough to fix mistakes

sameershah23

I was wondering if there is a way to toggle the power to the TV via HDMI CEC commands (sent by pi) and integrating a PIR sensor?
Example setup: The pi is always powered on. I walk into the room, the PIR senses me, and sends a power on signal to my TV via HDMI CEC command, and the mirror modules are displayed.

After a set duration, if no activity sensed by PIR sensor, a power off CEC command is sent to the TV by PI.

Has this been done before?

Any guidance would be much appreciated.

KirAsh4

CEC implementation is far and wide on monitors/tvs. There’s a client for the Raspberry Pi that you would have to install yourself, possibly (re)compile for your specific setup, and see if it is even able to communicate. This part is outside the scope of MagicMirror, like way out there.

You can start by reading the rpi forum: https://www.raspberrypi.org/forums/viewtopic.php?t=15749

SOLVED Auto on/off of the TV (not the Pi)?