UNSOLVED Pir sensor
Is there any working pir sensor exists? Pir sensor light is not working for me
@tanvir586 what is not working?
lite is the one that was updated most recently
@sdetweil I put the countdown for 1 min. but when the countdown start it goes to 54 then it go back to 1 min again.
my config is
sensorPin: 2, // GPIO pin
and the .js is
sensorPin: 0, // GPIO pin
commandType: ‘xrandr’, // Type of command used
title: “Automatic Standby”,
deactivateDelay: 1 * 60 * 1000, // 15 minutes
updateInterval: 1000, // 1 second
animationSpeed: 1000, // 1 second
@tanvir586 no, my question was , if u test the PIR connection/setup outside of MM does it work
using a python script?
I undertstand how it is SUPPOSED to work , and have tested modules on one of my systems before, but don’t
use PIR daily
@sdetweil Hi mate. Sorry I don’t know how to do that. I’m not a programming person. I’m copy past person actually
pugsly last edited by pugsly
This is what I use to put my monitor to sleep using a PIR sensor. I have a 3D printed case for the sensor that hangs under the mirror itself. The sensor does not have anything to do with the magic mirror software at all, in fact it just puts the monitor to sleep when no one is in the area.
@pugsly right, just trying to help w the debug. lots of things can go wrong, so, it’s best to start at the beginning before getting MM involved.