Read the statement by Michael Teeuw here.
Automatic installation
-
- Install jessie OS
- curl ok
- but same error = ligne 1 404 command no found
-
What is the exact command you are trying to run? And what instructions are you trying to follow? Just in case it’s an outdated one …
-
this one
curl -sL https://raw.githubusercontent.com/MichMich/MagicMirror/master/installers/raspberry.sh | bash -
-
Then there’s still something wrong with your base OS install. We can go back and forth with this and not figure out what’s going on. That’s not ideal. A better solution is if you can start by following the complete tutorial that I wrote up yesterday (and will complete today). The parts already written is how to get the Raspberry Pi 3 setup, updated, and configured properly before you even try to install MM² on it. Please try to follow the steps there before you try to run the automatic installer again. There are a lot of step-by-step instructions complete with screen captures for you to follow along with.
https://forum.magicmirror.builders/topic/236/complete-setup-tutorial
-
@KirAsh4 I will réinstall my rpi but there is no différence with your tutorial
-
ok found, the link yesterday was not the same v2-beta in place of master
ok now
-
can you please show the link ? did you managed to sot this ?
-
@gauka12345 use the scripts on my repo
https://github.com/sdetweil/MagicMirror_scriptsread the readme for the commands to enter
