MagicMirror² v2.6.0 is available! For more information about this release, check out this topic.

not working



  • when i installed mm it worked at all… but after reboot it didn’t loaded… and when i disconnect it out if eletric rPi don’t load anything



  • @branchi - Let’s see if you have pm2 monitoring the mirror.

    Start your pi.
    SSH into your pi.
    Run pm2 status all and see if you get a listing for the Magic Mirror process. If you get an error message, then you likely didn’t install pm2 properly.

    Report back and let us know your results.



  • i guess i have some bigger problem there … and that’s so my rPi not turning on… and i don’t have idea why



  • @branchi It’s going too far off topic but a hint:
    If your Pi is not booting, look at what the LED’s do. They may be blinking at the beginning. That resembles a code which you can look up with google.

    However, If it’s not too much work a completely new install is advisable.