Disabling IPv6 fixed the issue for me.

I’m running the pm2 logger.

MagicMirror finally went to the black screen again.

pm2 is throwing back this error:

[16798:0911/061159.534755:FATAL:webthread_impl_for_worker_scheduler.cc(32)] Check failed: started.

Any ideas?

@knubbl https://www.leowkahman.com/2016/03/19/disable-ipv6-raspberry-raspbian/

@binderth Can confirm this works!

Disabling IPv6 fixed the issue for me.

@shbatm said in PM2 MM2 Not starting on start up:

sudo pm2 startup systemd -u pi --hp /home/pi

Can also confirm this worked for me, too.

Thank you @shbatm

@j.e.f.f

I will add heatsinks once the frame is built and mounted. Thank you.

It’s at 69C without running magic mirror. Just the normal boot to desktop.

It’s dropped about 5 degrees. I’m going to continue to monitor it.

Even though it’s below 80c, the thermometer flickers.

Pi3. That’s the one.

Like I said, I have some iframe modules loading cameras, but I wouldn’t think that is intensive?

@Mykle1

I took off the top part of the case and it dropped 2 degrees. Right now it’s showing around 80C.