Offline
@1m2 that is you decision but i tell you @strawberry-3-141 has helped me in the past, and not only once. He is very gentle and his intention is the only one to help YOU.
We made a connection with TeamViever, he logged in to your raspi with putty and his work began.
Don’t worry, you can see at your monitor what he’s doing.
You cam manage boot options in raspi-config if you don’t have install jessi light.
execute following command.
sudo raspi-config
chose menu point
3 Boot Options
3B Splash Screen
and activate it wit “YES”
save and reboot with
sudo reboot
Next topic:
My screen show me a message with no signal for approx. 5 sec.
After that, the screen is complete black and off.
@schlachtkreuzer6 , @yawns , @andrei20wks , @reaper81
and here some pictures from the Mirror it self.
Hi, i do the same at first and restor my sw installation.
But after the same procedure of sw installation this error was again on top.
I resolve, by my sw, the reason for that was: motion must start after pm2 startin mm.
My mm start’s automaticly after rebooting.
My motion also. => collision of SW.
By doing motion in an cron job with delay time al was fun an running as iwant.
in my case i do following:
don’t foget to install screen.
sudo apt-get intsall screen
My motion is running in a screen session.
then the cronjob
crontab -e
and set motion with following parameters:
@reboot sleep 150; screen -S motion -dmS sudo motion -c /home/pi/motion/motion-mmalcam.conf
i hope this is helpfull for you and other persons here.
Eureka, great people who made it possible.
with yours i take 6 mirrors in my car.
I hope @Goldjunge_Chriz you prepare the glass a bit for transportation an you have some old used packaging material in your office.
If needed, i can give you some car dimensions about available space inside…
if i’m correct and no error in my calculation then i carry a weight of 63 kg only mirror glaas.
That’s ok.
Some packaging material an all mirrors are welcome in my car.
