@sdetweil thanks.

I found it had to get cheaper monitors that are both slim and gave small bezel. Not sure how will look with about 3-4cm of bezel in the middle.

Has anyone tried building a MM with an rpi4 and attaching two monitors?

I wanted two hook up to 21.5 inch monitors as it would be cheaper than getting a slim 30+ inch monitor.

Thanks @sdetweil , after a couple of reboots this is now working as expected. Not sure what the issue was, I will have to keep an eye on it. Thanks for the link on swap space, I will also look in that direction if I have any more of the same issues.

Hey sam (@sdetweil ),

Thanks for this, made my life a lot easier.

So, I just did a new build with Buster on a RPI Zero W. All looked good and I have configured mm2 to start on reboot of the Pi. I am start/stop/restart and check the status of mm2 and is looks to be working, the mm2 logs are also good with no error logs.

The problem I am facing is that the magicMirror page via chromium seems to try and load (white screen which changes to a pure black screen) however seems to fail/crash and go back to the Raspbian desktop.

This happens when I reboot the pi and also when I manually try to start/restart the mm2 service.

Anything you think I am missing?

Thanks

Hey @Sean ,

Thank you for your quite reply, you are correct the token.josn file was missing. Looks like I needed to run ‘node auth_and_test’ as sudo for this file to be created. Once I did this the photos started to appear :) just need to configure the size and position now.

Thank you again.

Regards

Nathan

Hi Sean,

Firstly thank you for this, it has great potential and is something that has been missing for such a long time compared to the alternative dakboard that I was forced to use to get photos displayed.

I have an issue though, I believe I have been through the steps correctly but can not get it to work. When I reboot my RPI2 it looks like the ‘auth_and_test.js’ is ran and this brings up the browser with googlin login and if I follow this through it gives me the code which is the same experience I have when running ‘auth_and_test.js’ in order to get the album id.

This then repeats itself every 5mins or so…

I have added the album id in the config.js but it does not seem to matter if I put a correct or incorrect one in here the same happens. It does not look like it trys to put images on the desktop so I don’t think the module is getting that far.

Any idea what I have done wrong?

Thanks

Nathan

@Kimzer Thanks for your quick replies. I deleted the Wunderlist and the enhanced Wunderlist folders/modules. Then created the Wunderlist folder again, then did npm install and this seems to have resolved the issue, must of been a problem with the Module.

@Kimzer Hmmmm, maybe. From the times I have missed/messed up config if normally comes up with something like …missing config.js

Hey,

I am having issues with the ‘MMM-Wunderlist’ and the enhanced version, when I add this in as a modules, then reboot the rpi. All I get is a blank screen? When I ssh in and then remove the module from the config.js, reboot then everything is back again. It does not seem to matter what I add the module config I get the same results.

Thanks

Nathan

Thanks @cowboysdude and @strawberry-3-141, will start looking at those.