Which solution for touching screen?

[com1cedric]

@sdetweil hello Sam, great, thanks a lot!

[rkorell]

@com1cedric where are you located?
Bckground: If in feasible distance I could send you my Hannspree Display for testing purposes …

Warm regards,
Ralf

[com1cedric]

@rkorell thank you very much for your proposal, but I just ordered it (I am in Switzerland).

I will then test it and send it back if it does not work.

I will inform you in any case whether if was successful or not.

Kind regards,

Cédric

[rkorell]

@com1cedric O.K. to me :-)
Good luck!

Ralf

[com1cedric]

@rkorell
hello @rkorell, wenn you tested your Hannspree Touch monitor, did you have to change any parameter on the raspberry, so that the “touching points” work?
On mine, it is working fine in landscape mode, but in the portrait mode, the points are “mirrored”, so that it is impossible to use it without parametring that. Thank you in advance, Cédric

[sdetweil]

@com1cedric didn’t you just.post solving this
https://forum.magicmirror.builders/post/124971

[rkorell]

@sdetweil , @com1cedric , yes, that’s what I would have suggested as well - use

Option "TransformationMatrix" "0 -1 1 1 0 0 0 0 1"

or similar in /usr/share/X11/xorg.conf.d/40-libinput.conf …

Regards,
Ralf

[com1cedric]

@sdetweil yes, this one can be closed. But I do not see the button to close it

[sdetweil]

@com1cedric this was started as a conversation, not an issue…