PM2 do not start at bootup on my RPI 2? Works fine on my RPI 3.

[tomyboy96]

Did not work…

only way to get PM2 to start is by using:

pm2 start mm.sh

[Baxer]

@tomyboy96 test with pm2 start mm.sh in crontab -e then and see if that works

[tomyboy96]

When trying to save this error shows up:

“/tmp/crontab.gpsLPh/crontab”:22: bad time specifier
errors in crontab file, can’t install.
Do you want to retry the same edit? (y/n)

[Baxer]

@tomyboy96 said in PM2 do not start at bootup on my RPI 2? Works fine on my RPI 3.:

errors in crontab file, can’t install.

do you have the @reboot before pm2 start mm.sh if you dont try with that

[tomyboy96]

@Baxer Worked! Thank you!

[Mykle1]

This post is deleted!

[bhepler]

I know you have a solution and all, but PM2 should already be running on your Pi as part of the installation process.

Did you save your PM2 state before reboot? If you’re willing to experiment, remove the PM2 commands from your crontab and reboot your mirror. Once it’s back up, start the mirror with pm2 start mm, wait for the interface to appear and then enter pm2 save.

Once PM2 has saved the state, reboot your mirror and MM2 should start after a few seconds.

[tomyboy96]

@bhepler
I tried this but somehow the RPI 2 didn’t boot up with pm2. Worked just fine with my RPI 3.