Able to use FLIC for stuff om the MagiMirror.
https://flic.io

@birdy yeah, but i used velcro tape insted of glue

@birdy i cut out flat pices that i drilled the board to.

@birdy i used one of thease.

http://www.biltema.se/sv/Fritid/Friluftsliv-och-camping/Kok-och-vatten/Vattendunk-2000023717/

Easy to bend och drill in

Here you have the solution!

https://forum.magicmirror.builders/topic/4499/pm2-do-not-start-at-bootup-on-my-rpi-2-works-fine-on-my-rpi-3/9

Good Luck!

@AlexHpoin Have u saved the config file in the right place?

@AlexHpoin What happens when you boot it up?

@birdy I used some stuff from this site when i configured the Rapi (Y)

https://www.raspberrypi.org/forums/viewtopic.php?p=269212

Good Luck!

@grillchips didn’t quite get the first question…

The film from mdpsupplies was good. better than expected. I ordered 5 meters for about 230 SEK if i remember right. in the end i only used about 2,5 meters… lol

After having the mirror for a couple of weeks i’ve decided to do some changes to it…
Since i use a mirror film the “mirror” do not get as clear as a regular mirror does. and also you have these small small small marks om the film from dust and stuff. IMPOSSIBLE to apply without this.
When i applied the film i was in a bathroom with the shower on so all the dust droped to the floor. Still not perfect and thats why i’m going to do this:

I was talking to a local glass shop here in town and they showed me a mirror glass that had a little transparency just enough to get a screens light to show up. my plan is to switch out the current glass with this mirror insted.
The new mirror glass would cost me about 400 SEK.

I will update this post when it’s done.

@birdy why the micro Hdmi?

I would recommend using dvi to hdmi since the Rapi will then recognise the cable directly and u won’t have to do any config to get the screen working propely.

If you wanna use a hdmi to vga i used this:

http://www.wish.com/c/557e6ed78fe81619f182a12b

Worked really good after a bounch of configures in the Rapi.