Alexa pi install, mic doenst work?

[Milad222]

@Milad222 said in Alexa pi install, mic doenst work?:

@Sean said in Alexa pi install, mic doenst work?:

arecord -d 10 test.wav && aplay test.wav

Yes that works…

pi@raspberrypi:~ $ arecord -d 10 test.wav && aplay test.wav
Recording WAVE ‘test.wav’ : Unsigned 8 bit, Rate 8000 Hz, Mono
Playing WAVE ‘test.wav’ : Unsigned 8 bit, Rate 8000 Hz, Mono

pi@raspberrypi:~ $
pi@raspberrypi:~ $ aplay test.wav
Playing WAVE ‘test.wav’ : Unsigned 8 bit, Rate 8000 Hz, Mono
pi@raspberrypi:~ $

[A Former User]

@Milad222
I’m not an expert, but Only I can say is…

• The error message caused by sound configuration fail.
• AlexaPi cannot understand your device “plughw:…” currently.
• I think it is related to alexapi daemon account and your personal account settings.
• https://github.com/alexa-pi/AlexaPi/wiki/Audio-setup-&-debugging This could be helpful.

Anyway, this is not realted with MagicMirror. You’d better get help from AlexaPi develpers or users on gitHub(or wiki)

[aro28]

Since i installed 3D sound card(external USB card with speaker and Mic) i disabled other internal HD web camera’s Microphone which came with my Touch Screen monitor. I used usual 3.5 mm jack mic.

1. Go to- -> sudo nano /lib/modprobe.d/aliases.conf
##options snd-pcsp index=-2 - This is my USB Mic which is came with internal HD camera on my monitor.
options snd-usb-audio index=-2
options cx88_alsa index=-2
options snd-atiixp-modem index=-2
options snd-intel8x0m index=-2

2. Go to --> sudo nano /etc/modprobe.d/raspi-blacklist.conf and added below command
blacklist snd_bcm2835

Above “snd_bcm2835” is my internal sound card

That’s all.

[Milad222]

@aro28

I order the Same USB soundcard like you today… I hope that it arrives tomorrow, do I have to install that also?

[aro28]

@Milad222
Hi,
It’s plug&play device and no need to install any drivers. Hope you it will help you.
I’m currently configuring Jarvis assistant. Did you hear about this?
Let me know if you will success with Alexa P
Best,

[Milad222]

@aro28
Javaris… i hear about that… but never try… does it work good?

tonight i will try the USB soundcard! you will hear it from me

Greatz

[Milad222]

So i finally have the 3D usb soundcard… with a 3.5mm jack mic… how verder now? What do i have to do…

[Milad222]

Thnx to @aro28 Alexa pi work! Thnx a lot!

[shadeaj]

Hi, I am confused on a matter. I have everything in the Alexa service set up and running but I have to scream in the mic to actually hear Alexa say “Yes?”. Does anyone know how I could fix this other than using the alsamixer tool? I go to alsamixer, select my usb mic pnp device, go to capture, raise it to 100, then esc out. Please help me…