PIR-Sensor - put your mirror to sleep if not used

paviro · May 21, 2016, 4:55 PM

@joerod please use Markdown on code snippets so it is easier to read! :) have you installed all the dependencies (also for the mirror itself?)
@MichMich any idea?

MichMich · May 21, 2016, 5:03 PM

Sorry, no clue. :(

joerod · May 21, 2016, 5:08 PM

@paviro I had to downgrade to node 5.0.0, I confirmed its that version of node. After the downgrade I removed the PIR module and did a git clone and then npm install in the folder. Still the same thing, is there a specific version of node 5 I should be using or a specific version of npm?

I’m running it from
/home/pi/MagicMirror/modules/MMM-PIR-Sensor

MichMich · May 21, 2016, 5:09 PM

Could you try it with node serveronly ?

paviro · May 21, 2016, 5:09 PM

@joerod also do npm install on the mm folder or install the whole thing from scratch :)

DirkS · May 23, 2016, 7:25 AM

@paviro as a feedback: i used the latest MMM branch and yours and it is working fine with my PIR sensor on a rpi2. I didn’t had to downgrade anything to node 5 (and i also don’t know what it is :D ) Thanks for your work. It is so great that the mirror is starting if a presence is detected!!

paviro · May 23, 2016, 7:42 AM

@DirkS glad to hear! :)

MechMatt · May 26, 2016, 10:37 PM

Hey Everyone!
I am trying to use this module to turn off/on a tv and im having a bit of trouble on the physical end of things… I got the module working perfectly (tested it with PIR and hdmi on/off). Now I am trying to use a relay with the PIR sensor to have the TV screen itself turn on and off. I was planning on wiring this to the TV power button (so it is essentially the same as pressing the on/off button).

I got the relay working… and I was about to take apart my tv when i thought…will even work for the on/off button? When it senses movement it will send the signal and then … turn off the tv I guess. As soon as the movement is undetected it stops sending the signal (or really pulse in this case)… just stopping wouldn’t turn the tv back on either. I guess it needs to send a pulse when it stops detecting movement, and then another one when it does again. Am I thinking about this wrong? Should I wire it to something else? Thanks in advance

MechMatt · May 26, 2016, 10:53 PM

@MechMatt On second thought, im having trouble with the relay as well… could you post a wiring diagram for the pi, relay, and tv? I’m not the best at electronics

paviro · May 28, 2016, 1:13 AM

To be honest the relay thing does not work that we’ll yet, still have to figure out some stuff related to how the Pi reacts when a monitor gets turned on after the boot process and not before.

As to your TV on/off button thing. The module simply puts s 3.3 volts on the configured Pin if the relay should be on and sets it back to 0 volts if it should be off. You can also configure it the other way around. Since I do not now how your TV button is wired I have no idea wheather it would work with this module without modifying some parts.