[Electron] display en screen after installing MMM-PIR-Sensor

sdetweil

@RIKKO14 is the screen actually powered off? did u enable ssh to get into a terminal window if desktop/mm has trouble?

if so I can issue commands there to turn on display tvservice or dpms…

I don’t use PIR, lots of troubles.

RIKKO14

I dont use ssh, only command on the py.
Instead of that, i think the py cut the power to the screen because the led of my screen is yellow like power off and not blue like something displayed.

RIKKO14

Yes, the screen actually powered off

RIKKO14

And I forgot to not the IP adress of my py, so I can’t use ssh now…
Pffff, I’m not lucky, every modules I want works instead of the PIR module…

RIKKO14

If i find my IP adress, Can you give me the commands to delete the problem ?

sdetweil

@RIKKO14 if u didn’t turn on ssh, it isn’t on, so can’t use it anyhow. look in your router to see what addresses were given out…

I do that quite often, then fix/reserve the address so I don’t have to remember

RIKKO14

ok, i find my IP adress (I’ve wrote it in excel file with some commandes i use) and I connected in SHH with putty,
thanks for your help to delete the commandh whose powered off my screen

RIKKO14

below my pm2 logs,
If that can help you…
https://www.cjoint.com/c/JHvqsqJ1QTT

RIKKO14

If it can help you this is my pm2 logs : https://www.cjoint.com/c/JHvqsqJ1QTT

sdetweil

@RIKKO14 looking at… hard to tell
do

pm2 stop 0
pm2 flush 
pm2 start 0

the will throw away the old logs…