Newsfeeder is going way to fast when showing news

Jalibu

I can confirm this error. Same on my MagicMirror:
It worked for weeks and then out of a sudden the speed changed to turbo-mode during runtime

Fozi

Same here. This behaviour started about 2 weeks ago. Some times the feeds cycle as expected, but then all of a sudden they rush through.

fribse

Yup, I saw it again this morning, odd.

fribse

@sdetweil Ok, I finally got it tested again.
If I go to my computer and open the webpage via remote it shows the right interval (this was what I did earlier), and the news cycles slowly as it should.
But on the raspberry pi, it still races through the news.
I haven’t restarted the Rpi just to keep the problem, but for me it’s not an easy test on the RPi itself, as the RPi is of course behind the mirror and headless.

Jalibu

I assume that for some reason some intervals are going crazy during runtime. The problem is gone, if you refresh the page, but it may come again after an uncertain time.

sek_is_back

As a workaround, till a solution is found

crontab -e
@daily sudo reboot

this will reboot the pi every night at 00:00 am.

Jalibu

@sdetweil I opened a Github issue for that: https://github.com/MichMich/MagicMirror/issues/2638

OberfragGER

I got the same issue since 2.16.
I have one image from 2.15 - no problem so far!

The strange thing… first after boot. It working some time like i should… Later… you see the news flashing… so the mirror is mostly black then.

Im using also MM-Pages tho flip to another page every minute.

sek_is_back

updated to develop version from GitHub
https://github.com/MichMich/MagicMirror/tree/develop

everything is fine now, Newsfeeder runs like expected since 1 Week

JoeFranz

@sek_is_back How do I do that?