@JoeFranz It is probably because of the current firmware 5.15
With

rpi-update b976c54917e240630c05a9b383010f1492bc61b4 

I installed version 5.10. It now works again with the standby on the HDMI connection.

Greetings Joerg
edited due to wrong quotes outside code block

Wolfsburg, Germany

Thank you, it works

@JoeFranz It is probably because of the current firmware 5.15
With

rpi-update b976c54917e240630c05a9b383010f1492bc61b4 

I installed version 5.10. It now works again with the standby on the HDMI connection.

Greetings Joerg
edited due to wrong quotes outside code block

Thanks @sdetweil for the link
It is probably due to the current firmware 5.15
With

rpi-update b976c54917e240630c05a9b383010f1492bc61b4

I installed version 5.10. It now works again with the standby on the HDMI connection.

Greetings Joerg

@sdetweil same here https://forum.magicmirror.builders/topic/17185/pir-sensor-problem-after-restart-raspi?page=1

@sdetweil Nothing happens in the window. PIR sensor broken?

@sdetweil ┌─────┬────────────────┬─────────────┬─────────┬─────────┬──────────┬────────┬──────┬───────────┬──────────┬──────────┬──────────┬──────────┐
│ id │ name │ namespace │ version │ mode │ pid │ uptime │ ↺ │ status │ cpu │ mem │ user │ watching │
├─────┼────────────────┼─────────────┼─────────┼─────────┼──────────┼────────┼──────┼───────────┼──────────┼──────────┼──────────┼──────────┤
│ 0 │ MagicMirror │ default │ 2.20.0 │ fork │ 12738 │ 64s │ 0 │ online │ 0% │ 2.6mb │ pi │ disabled │
└─────┴────────────────┴─────────────┴─────────┴─────────┴──────────┴────────┴──────┴───────────┴──────────┴──────────┴──────────┴──────────┘
pi@raspberrypi:~ $

@sdetweil Ok, that tests the PIR sensor. But since the Raspi doesn’t even let the monitor go into standby, I suspect that it’s due to Raspian. Screen blanking is activated in Raspi-Config, so the monitor should switch off after 10 minutes, right? But that doesn’t work either. Or does that have nothing to do with the PIR function of MM?

@sdetweil How can I test this?

@Egnos The sensor is correctly connected

@Egnos I did it according to this guide (in German) have the same pir sensor as in the guide.

@Egnos Doesn’t work either, the monitor doesn’t go into standby The Raspbian screensaver function does not seem to work. Can this be reinstalled?