MMM Hue Lights is not updated

[mumblebaj]

@JoeFranz Show me your config please.

[mumblebaj]

@JoeFranz I am working on a fix now to exclude multiple Groups/lights. Will deploy an update shortly.

Below is my config and it works fine. It will only display lights that are on.

                {
                    module: 'MMM-PhilipsHue',
                    disabled: false,
                    position: 'bottom_left',
                    config:{
                        bridgeip: "bridgeip",
                        userid: "userid",
                        refreshTime: 10000 * 5,
                        lightsOrGroups: "groups",
                        animationSpeed: 2 * 1000,
                        showOnlyOn: true,
                        showLabel: true,
                        colour: true,
                        hideSpecificGroups: true,
                        hideGroupsWithString: ["Kitchen", "Den"]
                        }
                },

The fix should be ready in the next hour. Just busy testing it.

[mumblebaj]

@JoeFranz Fix has been deployed, You can now exclude multiple Groups

[JoeFranz]

@mumblebaj said in MMM Hue Lights is not updated:

@JoeFranz Show me your config please.

{
		    module: 'MMM-PhilipsHue',
		    position: 'top_right',
		    config: {
			bridgeip: "192.168.178.xx",
			userid: "xxxxxxxx",
			colour: true
			
		    }
		},

[sdetweil]

@JoeFranz PLEASE, ALWAYS code block around config info …

[mumblebaj]

@JoeFranz Please match your config with mine and it should work

[JoeFranz]

@mumblebajI
did it and it works :-)
Now let’s see how long the display takes to update.

Thank you

[mumblebaj]

@JoeFranz From my config it checks the status of the lights every 5 minutes.

You can change that at anytime in the config and restart your mirror for the change to take effect.

[JoeFranz]

@mumblebaj
Is that correct in your config 5x10000?
On your module page it says 60x10000

[mumblebaj]

@JoeFranz You can set it to any time interval in milliseconds you like. I.e. 60*1000 = 1 minute etc. You can workout from there how often you would like to refresh.

[JoeFranz]

@mumblebaj Ok, the good news, the module works, the lights are updated. :-)
But I can’t change the time for the update, so no matter what value I enter, it always stays at around 10 minutes. :-(
This is part of the current config, after 10 minutes the lights will be updated.

                        refreshTime: 60 * 1000,
                        lightsOrGroups: "groups",
			animationSpeed: 2 * 1000,
			showOnlyOn: false,

[mumblebaj]

@JoeFranz Ah, there was an error in the spelling. I have updated and pushed a change. You can pull it again and restart. It should work properly.

[JoeFranz]

@mumblebaj Yes, it’s working now :-) Thanks so much! :thumbs_up:

[mumblebaj]

@JoeFranz No worries