[MMM-Remote-Control] Cannot GET /remote.html

[KristjanESPERANTO]

@mvrlogins said in [MMM-Remote-Control] Cannot GET /remote.html:

0|MagicMir | [2025-09-21 16:44:59.284] [ERROR] Error when loading MMM-Remote-Control: require() of ES Module /home/pi/MagicMirror/modules/MMM-Remote-Control/node_modules/uuid/dist-node/index.js from /home/pi/MagicMirror/modules/MMM-Remote-Control/API/api.js not supported.

To make it clear here as well: “require() of ES Module ... not supported” shows that you are using a very old (unsupported) Node version. Like I said in the GitHub issue, you have to update Node.

I recommend using NVM to update Node (like recommended on the Node website).

[kasperb]

@KristjanESPERANTO said in [MMM-Remote-Control] Cannot GET /remote.html:

the Node website

Experiencing the same issue… Created a clean install of MM over the weekend and am getting the same error. NVM is updated. :-(

[sdetweil]

@kasperb in config.js

address:”0.0.0.0”,
ipWhitelist:[],

[kasperb]

@sdetweil Yup, that’s what I have - sample of config here:

let config = {
	address: "0.0.0.0",	// Address to listen on, can be:
							// - "localhost", "127.0.0.1", "::1" to listen on loopback interface
							// - another specific IPv4/6 to listen on a specific interface
							// - "0.0.0.0", "::" to listen on any interface
							// Default, when address config is left out or empty, is "localhost"
	port: 8080,
	basePath: "/",	// The URL path where MagicMirror² is hosted. If you are using a Reverse proxy
									// you must set the sub path here. basePath must end with a /
	ipWhitelist: [],	// Set [] to allow all IP addresses
									// or add a specific IPv4 of 192.168.1.5 :
									// ["127.0.0.1", "::ffff:127.0.0.1", "::1", "::ffff:192.168.1.5"],
									// or IPv4 range of 192.168.3.0 --> 192.168.3.15 use CIDR format :
									// ["127.0.0.1", "::ffff:127.0.0.1", "::1", "::ffff:192.168.3.0/28"],

[Ypsimm]

@kasperb

In case you’re still interested…

After fighting with this for I don’t know how long, for poops and giggles I changed the permissions on my modules/MMM-Remote-Control folder to full r/w for all users…

Now I can access the remote control.

YMMV, change permissions at your own risk, etc.

[sdetweil]

@Ypsimm interesting. Git clone should set the permissions that way.

Did you install the module some other way than git?